Conveyor and sorter replacement parts
The wear parts that stop warehouse lines most often, cross-referenced to your original electrical and dimensional specs.
Motorized rollers and drives
24V and 48V DC motorized drive rollers (MDR), zone control cards, O-ring drive belts, and polyurethane drive wheels used across transport and accumulation zones.
We match tube outside diameter (such as 50 mm), between-frame width, roller face length, shaft end style (hex spring-loaded or threaded), cable exit end, nominal speed/torque, and connector pinout.
What to send for a quote
The label part number or measurements (voltage, tube diameter, length, shaft type, and connector pins).
Sensors and controls
Zone photo-eyes (diffuse, retro-reflective, through-beam), proximity switches, reflectors, and molded M8/M12 cordsets.
Matched on sensing mode, operating voltage, NPN vs. PNP switching, connector wiring, and mounting geometry. Any electrical component operating above 24V DC on AC mains power ships only with an accredited CSA, cULus, or cETLus certification mark.
What to send for a quote
The model code stamped on the sensor housing plus a close-up photo of the connector pins or wiring diagram.
Bearings and gearmotors
Precision shielded bearings, 2-bolt/4-bolt flange blocks, shaft couplings, roller chains, sprockets, and fractional-horsepower incline/transfer gearmotors.
Cross-referenced from stamped shield codes or bore, OD, and width measurements; gearmotors matched on gear ratio, output speed, mounting footprint, shaft size/keyway, and holding brake spec. AC gearmotors ship only with a verified CSA, cULus, or cETLus mark.
What to send for a quote
A sharp photo of the motor nameplate or the bearing code stamped on the seal, along with shaft rotation notes.
Belts, wheels and wear strips
Polyurethane drive wheels, timing and V-belts, elastomeric O-rings, belting, and extruded UHMW chain/guide wear strips.
Matched from unworn width, length, thickness, hub bore and keyway, and Shore A hardness where required. Stocking routine wear items ahead of peak avoids mid-shift belt snaps on busy merges.
Planning seasonal stock?
Send up to 10 recurring wear components for a free one-page shelf-stocking review.
Hard-to-find and legacy parts
When an OEM closes, merges, or discontinues a conveyor generation, the mechanical frames stay bolted to the floor. Send the model details or failed unit and we will check what can be matched safely.
Discontinued line?
We verify voltage, speed, torque, and mounting footprint, and say upfront when no safe equivalent exists.